List of errata
Last updated: 31/8/15
Chapter 5
Page 101, line 18. The formula for the Q-Q plot should use N (the total number of observations) rather than n (number of replicates) and should read “100(i−0.375)/(N+0.25)th percentile”. (Reported 25/8/14)
Page 102, line 3. The formula for the half-Normal plot should use N (the total number of observations) rather than n (number of replicates) and should read “[50+50(i−0.375)/(N+0.25)]th percentile”. (Reported 25/8/14, page number corrected 3/5/15)
Chapter 7
Page 137, Table 7.4. In ANOVA table, P for Block should be 0.281 (not 0.283). (Reported 25/8/14)
Chapter 8
Page 190, Figure 8.7. The vertical bar labelled ‘SED’ is in fact the LSD. (Reported 25/8/14)
Page 187, lines 4-6. The value and SE presented are from the normalised contrast. Using the contrast as given, the section should read as:
“Contrast ψ1 is estimated as −197.9 (SE 32.99), indicating that the yield of the control treatment is 198 units less than the average yield of the fungicide treatments with 95% CI calculated as −197.9 ± (32.99×2.179) = (−269.8, −126.0).” (Reported 25/8/14)
Chapter 9
Page 236, equation on line 24 The expression given for the SE is in fact the expression for the SED between the within-block means for two treatments. (Reported 21/2/17)
Chapter 11
Page 258, Table 11.1. In both ANOVA tables, the residual df should be 37 (not 36). (Reported 25/8/14)
Page 279, Figure 11.5 legend. Min SED=1.41 (not 1.14). (Reported 25/8/14)
Page 283, Figure 11.6 legend. Min SED=1.430 (not 1.449). (Reported 25/8/14)
Chapter 14
Page 351, line -10. The mean of hardness (x2) is −13.297 (not 13.297). (Reported 25/8/14)
Page 351, line -6. There are two missing minus signs in the last brackets, so although the result is correct, it would be more helpful it had been written as
28.66 – (16.93×3.30) – (−0.049 × −13.30) = −27.795
(Reported 25/8/14)
Page 363, Table 14.9. Some values in the last column of values (VIF) are incorrect (due to rounding error in calculations) and should appear as
Variate | R-squared | VIF |
Length | 0.998 | 538.01 |
Hardness | 0.029 | 1.03 |
Moisture | 0.017 | 1.02 |
Diameter | 0.998 | 537.89 |
(Reported 25/8/14)
Page 363, Table 14.10. The last column (P) is incorrect and should appear as:
Term | Parameter | Estimate | SE | t | P |
---|---|---|---|---|---|
[1] | α | -12.970 | 10.1545 | -1.277 | 0.203 |
Length | β1 | -40.155 | 14.5518 | -2.759 | 0.006 |
Hardness | β2 | -0.052 | 0.0162 | -3.238 | 0.001 |
Moisture | β3 | -1.805 | 0.9391 | -1.922 | 0.056 |
Diameter | β4 | 90.943 | 32.1755 | 3.924 | <0.001 |
(Reported 25/8/14)
Page 379, Exercise 14.4. Some units with missing observations had been erroneously included in the data set SLASH.DAT. This has now been updated on the website, but leaves only 160 trees from 49 plots (previously 174 trees from 50 plots). (Reported 6/9/14, exercise number corrected 3/5/15)
Chapter 15
Page 412, line 15. The denominator degrees of freedom for the Trt F-statistic should be 19 (not 16). (Reported 25/8/14)
Chapter 16
Page 437, line 14. Reference should be to Example 9.5 (not Example 9.2). (Reported 25/8/14)
Chapter 17
Page 478, Exercise 17.6 should be marked with an asterisk. (Reported 25/8/14)
Chapter 18
Page 515, Exercise 18.11 the description has got mangled and should read as follows: “The viability of carrot seed depends greatly on the conditions under which it is stored. Replicate batches of 100 seeds were stored in each of four different conditions (labelled A–D). Four replicate batches were sampled from each condition at pre-specified times: conditions A and B were sampled approximately every 60 days …” (Corrected 31/8/15)